This is an abbreviated version of the complete article.*
A nuclear stress test, also referred to as a myocardial perfusion scan, is one of the most commonly performed diagnostic heart tests.
During a nuclear stress test, a small amount of a radioactive isotope is injected into a person's bloodstream.
The distribution of the radioactive isotope in the heart muscle is recorded by a camera shortly after the person exercises. The camera produces three-dimensional images of the heart that show the physician exactly where the heart muscle may not be receiving enough blood and oxygen.
Coronary heart disease, or CHD, is the accumulation of plaque in a coronary artery sufficient to obstruct blood flow. One way that a physician diagnoses CHD is through a nuclear stress test. During a nuclear stress test, a small dose of a radioactive isotope is injected into the bloodstream. The radioisotope, or tracer, is carried through the bloodstream and into the myocardium, or heart muscle. Shortly after exercising, a special camera senses the radioactivity of the tracer and constructs an image of the heart. Parts of the heart muscle that receive normal blood flow receive larger amounts of tracer and appear brighter than areas that have inadequate blood flow.
The results of a nuclear stress test typically fall into three broad categories.
Blood flow defects during exercise, but not at rest; and
Blood flow defects during exercise and rest.
People are instructed to avoid eating and drinking after midnight the night before the test and discontinue certain medications. People should wear comfortable clothing in which to exercise. Pregnant women should check with their physician before engaging in a nuclear stress test.
Nuclear stress tests pose very little risk.
WHAT TO EXPECT
In the testing room, a nurse or technician will start an intravenous line, or IV, in the arm of the person being tested and will place approximately 10 small, sticky ECG electrodes with wires attached to them on the person's chest and back.
Recordings of the heart's resting activity are made before exercise begins. The patient begins the stress test by walking slowly on a treadmill. The speed and incline of the treadmill typically increase every 3 minutes to raise the patient's exertion level and increase the work the heart must do. Exercise typically lasts from 5 to 15 minutes.
When the person's maximum predicted heart rate has nearly been reached, the radioactive tracer is injected through the IV. The person continues exercising for about 1 minute to allow the tracer to disperse through the heart. The person is then asked to stop exercising and lie still on a table underneath a camera that rotates and senses the radiation being emitted by the tracer. The camera may record images for 30 to 45 minutes.
The person then relaxes for 3 or 4 hours, after which a second set of images are recorded.
For people who cannot exercise, the effects of exercise can be simulated with drugs, such as dobutamine and regadenoson.
The entire nuclear stress test may take between 2 and 6 hours.
Patients are encouraged to drink plenty of fluids to flush the radioactive tracer. They can resume normal activities immediately following the test.
Nuclear stress tests are safe; few complications are associated them.
*If you would like to read this article in its entirety, please call our office and ask to meet with one of our specialists to receive a Prescription Pad form.
*If you already have a Prescription Pad form, please login and follow the instructions listed on the form. If you experience any issues during the registration process, please call member services at 1-800-603-1420 for assistance.